
One-inch red console tape takes the low-tack labeling concept and gives it enough real estate to say something. Where the half-inch version handles fader strips and small tabs, this wider roll is built for full-word labels on the gear that fills a sound cart, a camera cart, and a DIT station, and its red color makes every one of those labels read as important from across the set.
Sound utilities use one-inch red to band and identify the hero pieces of a wireless package, to label the hot outputs on a distribution box, and to flag the antenna lines that must never be crossed with power. Camera assistants use it to mark exposed media on the red side of a shot-versus-blank system, so a card wrapped in red unmistakably means do not format. It is equally at home labeling the one drive in a stack that is still ingesting, the battery bank that is charging rather than charged, or the single cable in a loom that carries program. Anywhere a mistake would be expensive, a red label buys you a margin of safety.
Because this is genuine low-tack paper tape rather than cloth gaff, it applies and removes in seconds and leaves no adhesive on rented gear, painted racks, or plastic housings. The matte paper face holds Sharpie ink crisply without beading, so bold lettering stays legible under work lights.
• One-inch width fits full written labels, not just tabs
• Red color signals caution, hot circuits, and exposed media
• Low-tack adhesive safe for consoles, cameras, and cases
• Matte writable paper surface for bold Sharpie lettering
• Removes cleanly with no residue at wrap
• Tears easily by hand
• Typical roll length of 60 yards
Red one-inch console tape is in stock for purchase at Lightbulb Rentals' NYC, Philadelphia, and Pittsburgh locations. Add it to any rental order and give your cart a warning system that costs eleven dollars.
